[. . . ] • The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. • Do not leave the remote control in direct sunlight or near a heater. [. . . ] • Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction. • When the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvres to the extreme left or right in the COOL mode with the fan speed set to “SOFT ( )” for an extended period of time. Condensation may form on the louvres. GB- AY-AP9NR_GB. indd 6 11. 9. 30 5:02:55 PM COANDA AIRFLOW In cooling or dry operation, vertical adjustment louver is set obliquely upward to deliver cool air to the ceiling in order to avoid direct airflow. In heating operation, vertical adjustment louver is set downward to deliver the warm air down to the floor. TURBO OPERATION In this operation, the air conditioner fan works at "extra high" speed with a setting temperature of 15°C in COOL and DRY modes and 32°C in HEAT mode to rapidly cool or heat the room. ENGLISH During operation, 1 AIRFLOW button. press the COANDA • The remote control will display “ ”. 1 During operation, press the TURBO button. • The remote control will display “ ”. • The green TURBO lamp ( ) on the unit will light up. 1 1 TO CANCEL Press the COANDA AIRFLOW button again. TO CANCEL Press the TURBO button again. • The green TURBO lamp ( turn off. ) on the unit will NOTE: If you want the COANDA AIRFLOW setting in the TURBO mode, press the COANDA AIRFLOW button during the TURBO operation. • You can not set the temperature or fan speed during the TURBO operation. • After the unit has run for 30 minutes in TURBO operation, the fan setting will become the "HIGH" speed, and temperature setting will become 18°C in COOL and DRY modes. NOTE: GB- AY-AP9NR_GB. indd 7 11. 9. 30 5:02:56 PM PLASMACLUSTER OPERATION Plasmacluster ions released into the room will reduce some airborne mold. ONE-HOUR OFF TIMER When the ONE-HOUR OFF TIMER is set, the unit will automatically turn off after one hour. 1 During operation, press the PLASMACLUSTER button. • The remote control will display “ ”. • The blue PLASMACLUSTER lamp on the unit will light up. 1 Press the ONE-HOUR OFF TIMER button. • The remote control will displays “ ”. • The unit will stop operating after one hour. 1 1 CANCEL TO CANCEL Press the PLASMACLUSTER button again. • The PLASMACLUSTER lamp on the unit will turn off. TO CANCEL Press the CANCEL button. • The orange TIMER lamp ( turn off. ) on the unit will • Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. • To perform Plasmacluster operation in FAN only mode, press the PLASMACLUSTER button when the unit is not operating. The mode symbol of the remote control will go off and the fan speed can not be set AUTO. NOTE: Alternatively, turn the unit off by pressing the ON/OFF button. [. . . ] Up to 9. 5 hours, you can set in half-hour increments, and from 10 to 12 hours, in 1-hour increments. • The latest time setting will be memorized and will appear on the remote control display the next time you set the TIMER OFF or TIMER ON. [. . . ]